Hey,
Was wondering if I can get some help here. I just recently purchased a kit for the Reprap Prusa Mendel i2 from MixShop (the kit) & i2 Plastic Set from eBay.
I've gone through the videos but have gotten stuck on the Heatbed part.
RepRap Prusa Mendel Iteration 2 Assembly 11 - Heatbed - [
www.youtube.com]
I'm not sure, what type of wire is soldered to the heatbed, what/where to buy the 2 blue led's for the heatbed and what type of resistor to buy for the heatbed.
Thanks!
