i3 - Temperature won't stop rising (350deg)
Posted by kingoddball
|
i3 - Temperature won't stop rising (350deg) October 11, 2013 04:00AM |
Hi!
I have started to build a new printer; i3 based on a twelvepro wooden frame and EINSTEIN Variant.
Taurino Board, Ramps 1.4 and reprapdiscount graphical LCD.
Got it together, put together a firmware.
Everything moves, looks about right. Started the heaters.... Got hot..
LCD panel - I went to preheat PLA.
Temp rises - 100 > 150 > 180 > 200 > 250 > 300[[/u]/b]... Crap! Power off.
The Kaptop tape around nozzle even starts to smoke.
Can someone help with why it is not slowing/stopping temp at 180?
I've had an i2 previously - Was a great machine, now with a new owner, so it was time to rebuild a new machine
I have started to build a new printer; i3 based on a twelvepro wooden frame and EINSTEIN Variant.
Taurino Board, Ramps 1.4 and reprapdiscount graphical LCD.
Got it together, put together a firmware.
Everything moves, looks about right. Started the heaters.... Got hot..
LCD panel - I went to preheat PLA.
Temp rises - 100 > 150 > 180 > 200 > 250 > 300[[/u]/b]... Crap! Power off.
The Kaptop tape around nozzle even starts to smoke.
Can someone help with why it is not slowing/stopping temp at 180?
I've had an i2 previously - Was a great machine, now with a new owner, so it was time to rebuild a new machine
Sorry, only registered users may post in this forum.