Can't figure out how to mount JHead to Wade's extruder June 29, 2014 09:41AM |
Registered: 9 years ago Posts: 1 |
Re: Can't figure out how to mount JHead to Wade's extruder June 29, 2014 01:46PM |
Registered: 10 years ago Posts: 439 |
Re: Can't figure out how to mount JHead to Wade's extruder June 29, 2014 09:38PM |
Registered: 10 years ago Posts: 62 |
Re: Can't figure out how to mount JHead to Wade's extruder July 01, 2014 01:23AM |
Registered: 11 years ago Posts: 1,592 |
Quote
Ralph.Hilton
I wouldn't mount it. Cheap ripoff hotends are a generally unreliable and cause a lot of problems.
[e3d-online.com] is a great, reliable hotend. Using the cheap one will probably cost more in wasted filament than paying the extra for a good one.
Re: Can't figure out how to mount JHead to Wade's extruder July 01, 2014 02:56AM |
Registered: 11 years ago Posts: 408 |
Re: Can't figure out how to mount JHead to Wade's extruder July 01, 2014 08:03AM |
Registered: 10 years ago Posts: 167 |
Quote
waitaki
Cheap rip-off? Isn't the j-head an open source design? They can't be any worse than those that many of us make in our sheds and garages and which serve us well. The E3D is a decent hot-end but it too has its issues.