How can I get my solid infill to be a more continuous pass?
Infill in a cube is fine with generally 2 continuous paths, but I'm getting alot of retractions and jumping around in the gcode for this gear I'm trying to print. i.e. passing right to left, it will retract, jump over several extrusion paths, infill some, then come back to the paths the were skipped, instead of just filling left to right continuously like in a cube.
I can make it worse by decreasing the Sharpest Angle, but not better by increasing it.
Suggestions?
Edited 1 time(s). Last edit at 10/27/2012 08:56PM by Dirty Steve.