I'm looking to have this part produced (machined/printed/whatever), if the lip around the bottom is an issue, I also have a design without it, although it is prefered. From my estimates, it is around 18 ccs of material ~ 1 cu in.

It should be in black, if possible, and needs to be made from plastic because the part must bend for the latch to be released.

If you're able to make it, send me an email and quote back at joehms22[at]gmail[dot]com

Thank you!
- Joseph

That stl unit is inches, isn't it ? Read in mm it it something like 3 by 2,5 mm big only.

---

Most of my technical comments should be correct, but is THIS one ?
Anyway, as a rule of thumb, always double check what people write.

I'm not entirely sure. I designed in mm and exported, but I don't know what the conversion in MeshLab did to the piece.

I may have found someone to print it as well.

Got the part printed, thanks for everyone that wanted to help!