New aluminum profile for delta like printers, reducing nb of parts January 31, 2014 03:56PM |
Registered: 11 years ago Posts: 25 |
Re: New aluminum profile for delta like printers, reducing nb of parts February 01, 2014 09:20AM |
Registered: 11 years ago Posts: 903 |
Re: New aluminum profile for delta like printers, reducing nb of parts February 01, 2014 01:45PM |
Registered: 11 years ago Posts: 25 |
Re: New aluminum profile for delta like printers, reducing nb of parts February 03, 2014 06:05PM |
Registered: 11 years ago Posts: 903 |
Re: New aluminum profile for delta like printers, reducing nb of parts February 04, 2014 01:30PM |
Registered: 11 years ago Posts: 25 |
Re: New aluminum profile for delta like printers, reducing nb of parts February 04, 2014 01:53PM |
Registered: 11 years ago Posts: 553 |
Quote
erylon
May be I posted in the wrong topic to gain wider interest?
@vreihen:your point is interesting. Then why people managed to setup makerslide and v-slot ? They could have done the same result using available guidings. Is it because the price went down ?
If so, with a new "delta profile" there would be even less parts so it should work : why nobody is then interested ?
About making on our own lacking parts vs mass production. I would say that printing parts cost money and takes time. The printed parts to have a delta may be somewhere close to 1kg of plastic ~35€ to be compared to the added cost, if any, of a "delta profile". Not counting advantages of higher rigidity & perfect geometry. The enlarged geometry above doesnt require drilling. Mounting can be achieved with angle brackets at about 2€ each : so 24€... or drilling : 0€ and a gain of 35€.
May be the ratio quality/gain is to low?
Please readers, give us your opinion !
Thank you all !
Re: New aluminum profile for delta like printers, reducing nb of parts February 11, 2014 04:41PM |
Registered: 12 years ago Posts: 15 |
Re: New aluminum profile for delta like printers, reducing nb of parts February 12, 2014 03:21AM |
Registered: 12 years ago Posts: 1,807 |
Re: New aluminum profile for delta like printers, reducing nb of parts February 12, 2014 12:57PM |
Admin Registered: 11 years ago Posts: 3,096 |