Experience with magnetic joints July 11, 2015 06:01AM |
Registered: 9 years ago Posts: 6 |
Re: Experience with magnetic joints July 11, 2015 08:25AM |
Registered: 10 years ago Posts: 903 |
Re: Experience with magnetic joints July 11, 2015 03:18PM |
Registered: 9 years ago Posts: 13 |
Re: Experience with magnetic joints July 11, 2015 07:13PM |
Registered: 9 years ago Posts: 43 |
Re: Experience with magnetic joints July 12, 2015 05:00AM |
Registered: 9 years ago Posts: 6 |
Re: Experience with magnetic joints July 14, 2015 11:01AM |
Registered: 9 years ago Posts: 17 |
Re: Experience with magnetic joints July 14, 2015 05:30PM |
Registered: 11 years ago Posts: 580 |
Re: Experience with magnetic joints July 15, 2015 07:06PM |
Registered: 10 years ago Posts: 903 |
Quote
pineapple
However, I think you're touching on two much larger inherent flaws with magnets:
Re: Experience with magnetic joints July 15, 2015 10:23PM |
Registered: 11 years ago Posts: 580 |
Re: Experience with magnetic joints July 17, 2015 10:04AM |
Registered: 10 years ago Posts: 189 |
Re: Experience with magnetic joints July 20, 2015 11:33AM |
Registered: 9 years ago Posts: 49 |
Re: Experience with magnetic joints July 23, 2015 06:16AM |
Registered: 9 years ago Posts: 6 |
Re: Experience with magnetic joints July 23, 2015 09:30AM |
Registered: 9 years ago Posts: 346 |
Re: Experience with magnetic joints July 23, 2015 01:31PM |
Registered: 9 years ago Posts: 6 |
Re: Experience with magnetic joints July 23, 2015 06:24PM |
Registered: 9 years ago Posts: 346 |
Re: Experience with magnetic joints July 23, 2015 11:40PM |
Registered: 10 years ago Posts: 189 |
Re: Experience with magnetic joints July 24, 2015 02:10PM |
Registered: 10 years ago Posts: 469 |
Re: Experience with magnetic joints July 25, 2015 09:23AM |
Registered: 9 years ago Posts: 346 |
Quote
janpenguin
@LarsK
The effector shape is familiar to a cheap Kossel Kit from China.
It has design flaw that creates lifting of diagonal rods when the effector moves to the edge.
I spent hours to fix it with another builder who bought the Kossel kit. Replacement of six diagonal rods, installation of springs didn't solve the problem.
Re: Experience with magnetic joints July 25, 2015 09:41AM |
Registered: 10 years ago Posts: 14,684 |
Quote
LarsK
I have the kossel K800 with countersunk magnets like you say. I also now have some normal round magnets that I would like to somehow implement to improve performance.
My performance is probably not enhanced by one of my countersunk being broken but there is no system in where it disconnects. Some days one side, another day another... In the picture you see one of my round magnets put on the steel ball but it does not feel like it makes much difference.
So if you have ideas fire away. I have stopped using it now because it is just too unreliable and I have a fully working other printer.
Re: Experience with magnetic joints February 07, 2016 08:54AM |
Registered: 9 years ago Posts: 1 |