Welcome! Log In Create A New Profile

firmware

formulavee

firmware
May 06, 2014 10:08AM

Registered: 11 years ago
Posts: 13

What is a firmware that is simple to use and basic that I can upload to a Atmega 1284p on a Gen 7 1.5 for use as a simple 3 axis mill?

I am new to programming and have been having problems with teacup,marlin and sprinter on the ardunio IDE

got the boot loader uploaded with the USBASP and the test firmware working

Any help would be much appreciated spinning smiley sticking its tongue out

Edited 1 time(s). Last edit at 05/06/2014 10:10AM by formulavee.

Reply Quote

vreihen

Re: firmware
May 06, 2014 07:44PM

Registered: 12 years ago
Posts: 903

Have you tried the Repetier web config tool for building custom firmware?

http://www.repetier.com/firmware/v091/

Reply Quote

Dust

Re: firmware
May 07, 2014 04:01AM

Admin
Registered: 15 years ago
Posts: 7,305

GRBL [github.com]

Reply Quote

formulavee

Re: firmware
May 07, 2014 04:55AM

Registered: 11 years ago
Posts: 13

I have had a go at grbl but I couldn't get it to work. I loaded up repetier and when it went to compile it gave me this....

Any help would be fantastic spinning smiley sticking its tongue out

Reply Quote

Traumflug

Re: firmware
May 07, 2014 04:59AM

Registered: 15 years ago
Posts: 7,616

Teacup is the smallest and fastest firmware. It doesn't have as many features as Marlin or Repetier, but has worked out essential stuff more carefully. Accordingly you get movements always respecting physics and up to 3 times higher step rates than e.g. Repetier.

Generation 7 Electronics	Teacup Firmware	RepRap DIY