That's good - I have a student working on synthesising PLA too, so his
results will go on the wiki as soon as.
Best wishes
Adrian
Dr Adrian Bowyer
[
staff.bath.ac.uk]
[
reprap.org]
Quoting Vik Olliver :
> I finally got around to dropping off the PLA with Allan Booth in
> Henderson. He's partially bemused but very sympathetic to our cause. I
> think he sees the potential market for a lot of PLA...
>
> He says he's busy for the next couple of weeks, then should be able to
> extrude our filament. Their machine is probably going to run at +/-0.2mm
> so I told him to do it slightly undersized if there is an issue - this
> is to ensure our 3mm holes in the PTFE rod don't get bunged up.
>
> Vik :v)
> -------8<---------8<---------8<---------8<---------8<---------8<-----
> "Every gun that is made, every warship launched, every rocket fired,
> signifies in the final sense a theft from those who hunger and are not
> fed, those who are cold and are not clothed."
_______________________________________________
Developers mailing list
Developers@reprap.org
[
reprap.org]
