I just ordered a RAMPS 1.4 setup with SD card but im not sure the best route to go with it as ive used a printrboard clone in the past. Ive changed cause eventually im going dual and then triple bowden. Any ideas? What firmware should i use as well as host controller. Any help would be greatly appreciated as Iam new to RAMPS. Also any installation tips and does as well as donts. Example. Dont unplug motors while ramps is on. The arduino and sd card is a iduino mega 2560.
--------------| For Everything |--------------------------
Check it out here:
[
reprapsquad.wordpress.com].
---------| For Everything Prototype Related |------
Now featuring comp case mods:
[
RepRapLab.wordpress.com]
--------------| Find us at Twitter|------------------------
@REPRAPSQUAD (RS Main)
[
mobile.twitter.com]
@REPRAPSQUADHQ (ProtoLab)
[
mobile.twitter.com]
