Hi there,
Just fitted a new RAMPS 1.4 to my printer, did a few changes in Arduino before launching prontface and this is what I get when trying to connect;
Connecting...
~†ø~˜€fæàžþž˜˜~f†ø†žžfæàžþž˜˜††žf~ffžøž~`~f`˜€
fæàžþž˜˜˜`fæàžþž˜˜††žf~ffžøž~``fà`˜€fæàžþž˜˜fæàžþž˜˜††žf~ffžøž~`~f``˜€
fæàžþž˜˜††ž`æø~þžfæàžþž˜˜††žf~ffžøž~`~f`˜€þžžž˜€fæàžþž˜˜††žfþffžøž~`~fà``˜€
fæàžþž˜˜††žf~ffžøž~`~˜xf``˜€
fæàžþž˜˜††žf~ffžøž~`~ž†xfæàžþž˜˜††žf~ffžøž~``f`˜€fæàžþž˜˜fæàžþž˜˜††žf~ffžøž~``fà`˜€fæàžþž˜˜fæàžþž˜˜††žf~ffžøž~``fà`˜€fæàžþž˜˜fæàžþž˜˜††žf~ffžøž~``fà`˜€fæàžþž˜˜
Any ideas as to what is going on?
Thanks!
