Motor not moving as expected with RAMPS 1.4 and Marlin January 20, 2017 07:31AM |
Registered: 7 years ago Posts: 29 |
Re: Motor not moving as expected with RAMPS 1.4 and Marlin January 20, 2017 07:58AM |
Admin Registered: 13 years ago Posts: 7,005 |
Re: Motor not moving as expected with RAMPS 1.4 and Marlin January 20, 2017 08:05AM |
Registered: 7 years ago Posts: 29 |
Quote
Dust
Blinking X,Y Z on the display just means you have not homed the axis, so it thinks 0 is where ever it was at power on.
Most likely (as most people seem to miss this) you have not installed any stepper micro stepping jumpers under to stepper modules
Re: Motor not moving as expected with RAMPS 1.4 and Marlin January 20, 2017 09:10AM |
Registered: 7 years ago Posts: 759 |
Re: Motor not moving as expected with RAMPS 1.4 and Marlin January 20, 2017 09:13AM |
Registered: 7 years ago Posts: 29 |
Quote
obewan
Please dont power it up with the endstops plugged in as show in the picture, you have them conected to +5v and gnd.
2 wire endstop switches should be plugged into the 2 outer pins, gnd and signal
Re: Motor not moving as expected with RAMPS 1.4 and Marlin January 20, 2017 03:54PM |
Registered: 7 years ago Posts: 759 |
Re: Motor not moving as expected with RAMPS 1.4 and Marlin January 20, 2017 05:54PM |
Admin Registered: 13 years ago Posts: 7,005 |
Quote
harlandraka
Yeah, I noticed and changed them, but they don't seem to work, when I click the endstop marlin does nothing.
If I click it while moving, motor doesn't stop, and the "X" continues blinking...