Wonder if anyone can help

I just downloaded the RAMP 1.4 design files from the wiki : [reprap.org]
With a view to having some pcbs made, when I ran the DRC I get about 184 'Stop Mask' errors, just wondering if anyone else who has had these made has experienced this or any other issues prior to me getting some made?

Any help appreciated, thanks

*Update I also get similar errors with the RAMPS 1.3
*Update 2 Argh the Ramps 1.3 page links to a zip file thats actually the RAMPS 1.4 file, how do I get the real 1.3 vs?

P.S. its RAMPS 1.3 That I wish to get made, anyone know how to get to the 1.3 files ?

*Update 3 got RAMPS 1.3 [reprap.org] it has 87 stop mask errors
regards
Al

Edited 5 time(s). Last edit at 09/06/2011 09:58AM by Folknology.

I purchased a RAMPS 1.3 kit from Ultimachine and soldered it myself.
I have not had any problems with the board. The board was produced by ???.
I know some of the traces are getting smaller and might be difficult to make as there is so much packed onto the board.
You might want to see who made Ultimachine's RAMPS boards.
There was a note (maybe on the 1.2 site) that talked about anything above 1.2 would be difficult to make unless you had a quality process involved with the traces.