Dear Guys,-

I have a Huxley printer and it prints fine, but when I press print in pronterface it takes a while before the printing starts and the heatbed turns off and the heater temperature is only measured. When it then begins printing the heatbed temperature is available but I need to set the heatbed again since it is turned off.

Does anyone have a suggestion?

/Nimal

What are you using to slice your files? if using slicer and you have compatable heat bed control, you can set the heat bed temp when you slice the model.

---

Ryan
Quality Engineer & Hobbyist
thingsandtrains.blogspot.com

Hi Ryan,-
I am using Skeinforge. When you write "if using slicer" do you mean slic3r?
/Nimal

Yeah i mean slic3r, and i dont know anything about skeinforge, maybe someone else has some ideas?

---

Ryan
Quality Engineer & Hobbyist
thingsandtrains.blogspot.com