Stepper Motors Not Moving just Beeping May 25, 2019 12:49PM |
Registered: 4 years ago Posts: 7 |
Re: Stepper Motors Not Moving just Beeping May 25, 2019 02:26PM |
Admin Registered: 16 years ago Posts: 13,891 |
Re: Stepper Motors Not Moving just Beeping May 25, 2019 04:39PM |
Registered: 4 years ago Posts: 7 |
Re: Stepper Motors Not Moving just Beeping May 28, 2019 11:48AM |
Registered: 7 years ago Posts: 619 |
Quote
Ryanrocksforever
I am makink my own 3d printer, and I am having some issues, I do not know whether it is with the firmware or the hardware.
Problem
Whenever I try and move the x or y axis on my printer, either through protoneer or the LCD display, the stepper motors will just move a tiny bit and make a beeping noise, and not move any more. I am using Nema 17 stepper motors with A4988 drivers. I am using a rumba control board because I have dual extruders and dual z axis. I wired the dual Z axis motors in parallel, and the z axis works fine but all the other axis's do not. When I start a print on protoneer, it try's to home, but cannot so I just trigger the end stops my self, and when it starts printing all of the stepper motors work fine but the problem is is that it is not printing in the center because it cannot home. Any help would be appreciated.
BTW
I am using marlin configured for two extruders 5 end stops, and a reprap discount full graphical controller.
Re: Stepper Motors Not Moving just Beeping May 28, 2019 05:12PM |
Registered: 4 years ago Posts: 7 |
Re: Stepper Motors Not Moving just Beeping May 28, 2019 05:26PM |
Registered: 7 years ago Posts: 619 |
Quote
Ryanrocksforever
Thank you I will try all of this
Re: Stepper Motors Not Moving just Beeping May 28, 2019 05:28PM |
Registered: 4 years ago Posts: 7 |
Re: Stepper Motors Not Moving just Beeping May 28, 2019 06:08PM |
Admin Registered: 16 years ago Posts: 13,891 |
Re: Stepper Motors Not Moving just Beeping May 28, 2019 09:20PM |
Registered: 4 years ago Posts: 7 |