about my print quality
Posted by ikaarus
|
about my print quality December 30, 2013 08:29PM |
Hi I print some models on my marlin firmware based 3d printer. So i attached sample prints.
Layer thickness 0.1 mm material pla 195 degree print. Software cura. Where am I making a mistake? it's about flow rate? I've never tried to change flow rate. I tried 210 degree and 180 degre and I saw the same results.
Many thanks.
Layer thickness 0.1 mm material pla 195 degree print. Software cura. Where am I making a mistake? it's about flow rate? I've never tried to change flow rate. I tried 210 degree and 180 degre and I saw the same results.
Many thanks.
Sorry, only registered users may post in this forum.