So, I am still in the "calibration" phase of learning how to print 3d. I have noticed that my prints seem to have excess filament on it in places where there are suppose to be gaps... So this leads me to a question that is better answered by more experienced people...
Is faster printer better quality or is slower printing better quality.
I am using Pronterface to print and I am going at:
XY: 3000mm/min
Z: 200mm/min
Heat: 205.0
Extrude: 4mm @ 48mm/min
I'm using PLA with no heatbed and painters tape. There is no warping on the base and the objects are sticking just fine.
Thanks for the help.
Will
Edited 2 time(s). Last edit at 01/21/2014 07:28PM by iamwill.