Layer starting issues

Once im printing it looks GREAT but the starting points are very obvious in my prints.
Im printing ABS at 225c with bed at 110c. Layer height at .2mm and retract at 1mm at 30mm/sec and perimiters at 50mm/sec.
Any suggestions on where to start to not get blobs at the start of my layers?
Bottom:

The start area and the side right around the corner.


Back side is great:

Nothing? wow I figured someone could help me out diagnosing the starting issue...

It could be that your accleration is set too low.

What would be a good value?
Right now I think the value is at 500