Extruder not heating April 27, 2014 11:06PM |
Registered: 10 years ago Posts: 4 |
Re: Extruder not heating April 27, 2014 11:32PM |
Registered: 10 years ago Posts: 4 |
Re: Extruder not heating April 28, 2014 12:22AM |
Admin Registered: 13 years ago Posts: 7,007 |
Re: Extruder not heating April 28, 2014 12:32AM |
Registered: 10 years ago Posts: 4 |
Re: Extruder not heating April 28, 2014 01:34PM |
Registered: 10 years ago Posts: 4 |
Re: Extruder not heating April 28, 2014 10:03PM |
Registered: 11 years ago Posts: 1,592 |
Re: Extruder not heating May 01, 2014 06:20AM |
Admin Registered: 11 years ago Posts: 3,096 |
Re: Extruder not heating May 01, 2014 08:25PM |
Registered: 10 years ago Posts: 8 |
Re: Extruder not heating May 02, 2014 01:31AM |
Registered: 11 years ago Posts: 1,171 |
Quote
ksk
Soldering the parts is usually much better than crimping, you get much better contact between the two surfaces. Crimping can work loose especially if the wires are moving backwards and forwards, that could be what caused the problem in the first place. Use flux to make sure you don't get a dry joint.
Re: Extruder not heating May 02, 2014 01:21PM |
Registered: 10 years ago Posts: 8 |