Good day all
Did my 1st test print and some reading on the wiki. Bought a I3 Prusa: [
www.3dprintingstore.co.za]
0.4 nozzle 1.75 filament - printing abs on 110 bed and 240 extruder temperature. I have imported a prusa.ini config file to repetier-host sli3er that came with the printer. Layer height = 0.3 etc.
If you look at the tiny bunny - both rear legs/butt and back are nice and smooth, but underneath his tail and just above his front feet to his chin is rough layers and the bottom aswell.
Any ideas what should be changed - maybe layer height/thickness?
Thanks all