top solid layers in slicer

I recently dabbled a bit in Cura and although its to simple to use for most prints i had better top solid layers than I get in slicer.

So my main issues in slicer are that in the corners there is too much material. it like the spacing is to small and the layers are folding over each other.

and the second shows up next to the top solid perimeter. the layer near the perimeter extrusion looks stretched to thin. its like isnt supported from the layer under it.

any ideas?

Make sure you have the filament and nozzle sizes set correctly in Slic3r...

---

-David

Find me online at:
Thingiverse
Instructables.com
LinkedIn
Facebook

Check out my FolgerTech Prusa i3 (plexi) at MindRealm.net

Those are confirmed and now they gotten better by themselves, they also arent as pronounced when I go to 0.1mm layerheight.
What I would like to have in slic3r besides the flow rate is a setting to space the the perimeters and infill closer together. I have the feeling that could in some situations.