Square objects are not really square [Kossel/Delta]

thetazzbot

Square objects are not really square [Kossel/Delta]
October 06, 2015 09:56PM

Registered: 8 years ago
Posts: 396

I just printed a square/cube. measured the sides and they are different by about .5mm

Any ideas what I can adjust?

Reply Quote

Ezrec

Re: Square objects are not really square [Kossel/Delta]
October 07, 2015 03:24PM

Registered: 8 years ago
Posts: 127

I had a similar issue, and resolved it by adding per-tower DELTA_RADIUS adjustments - my spider was slightly imperfect.

Reply Quote

Newer Topic Older Topic

Print View RSS

Sorry, only registered users may post in this forum.