Welcome! Log In Create A New Profile


Closed chambed for Prusa i3

Posted by barakori 
Closed chambed for Prusa i3
November 02, 2015 03:07PM
I have a very common problem - my ABS prints are curling, mostly at the bottom. The bed is perfectly level and runs at ~100C.

I decided to try building some form of closed chamber for my printer. The real question is - will this damage the stepper motors?

With the current Prusa i3, it's going to be difficult to have the motors outside the chamber.
Also, what about the electronics?

I can probably control the temperature with a simple Arduino, hooked to a thermometer and a fan.

Any recommendation / suggestions?

Re: Closed chambed for Prusa i3
November 02, 2015 05:27PM
Sorry, I accidentally post this here. It better fits "Reprappers". Please add information in the similarly titled post there.
Sorry, only registered users may post in this forum.

Click here to login