Hey Everyone,
Just starting with my first 3D printer. RepRap Prusa i3. Everything has been going pretty smoothly until now. I have built it, wired it, installed software properly, etc... I am now at a point within the Repetier Software that after I have a print job Sliced and sent to print the Extruder and Heat Bed warm up then Repeteir states "ETE 3m:12s" and nothing happens.
Any help and insight would be greatly appreciated.
The only thing I notice is that the Error codes says "echo: Active Extruder: 0". The extruder heats up fine, so not sure why it says "0"