Cold Bed & PLA: Kapton or Blue Tape January 10, 2017 07:32AM |
Registered: 7 years ago Posts: 3 |
Re: Cold Bed & PLA: Kapton or Blue Tape January 10, 2017 08:56AM |
Registered: 7 years ago Posts: 558 |
Re: Cold Bed & PLA: Kapton or Blue Tape January 10, 2017 09:11AM |
Registered: 7 years ago Posts: 2 |
Re: Cold Bed & PLA: Kapton or Blue Tape January 10, 2017 10:38AM |
Registered: 7 years ago Posts: 3 |
Thx for the details! I've tried this in the past on another printer. PEI needs the heat to workQuote
PDBeal
Not sure if PEI will work cold or not
Just so I understand, PLA doesn't stick to Kaptop without a PVA solution on top of the kapton? The problem here is that the PVA solution needs some heat to melt a bit. I've tried glue and hairspray on a cold bed on another printer and it was useless.Quote
Smok1n
Again, according to what I've read, PLA doesn't stick at all without additional prep such as glue stick or PVA and water solution..
Re: Cold Bed & PLA: Kapton or Blue Tape January 10, 2017 07:20PM |
Registered: 7 years ago Posts: 759 |
Re: Cold Bed & PLA: Kapton or Blue Tape January 14, 2017 02:34AM |
Registered: 8 years ago Posts: 195 |
Re: Cold Bed & PLA: Kapton or Blue Tape January 15, 2017 11:37AM |
Registered: 9 years ago Posts: 288 |
Re: Cold Bed & PLA: Kapton or Blue Tape January 15, 2017 08:26PM |
Registered: 9 years ago Posts: 21 |
Re: Cold Bed & PLA: Kapton or Blue Tape January 16, 2017 07:43AM |
Registered: 7 years ago Posts: 3 |
Re: Cold Bed & PLA: Kapton or Blue Tape January 17, 2017 09:44PM |
Registered: 7 years ago Posts: 56 |