Hi all
I have a Prusa steel wit a prindbed of printbite
Tried already a lot of things to get the TPE filamant to stick to the headbed
first layer extruder temprature at 260c
- Printbite cold
- Printbite 30c
- Printbite 70c
- Printbite 110c
- Printbite with lac3D cold
- Printbite with lac3D 110c ( a little bit more adhesion )
- kapton tape cold
- kapton tape 110c
- blue tape cold
- Raft of ABS at with 110c bed ( very bad adhesion of the TPE to ABS )
The thing that they all had in common is that it doesn't stick at all.
I am running out of ideas.
This is with kapton tape
Edited 3 time(s). Last edit at 12/22/2017 12:36PM by amigob.
P3steel DXL, with Due/RADDS/Raps128 dual Wade's extruder
Attachments:
open |
download -
IMG_20171222_155211.jpg
(457.8 KB)