I am running an MKS SBASE board from a 24v power supply and a 12v thermistor. I've configured it to work with the 12v thermistor (I did everything it told me to in the documentation?).
Anyways, here's my config: [
hastebin.com]
The only difference between that one and the one applied to my printer is that #temperature_control.hotend.max_pwm is uncommented.
After I uncommented it,I noticed it took a longer amount of time, but it still didn't stop heating up.
It's gone well over 400 C. And it even deformed one of my heating blocks.
Any help is appreciated, I'm just trying to print as safely as possible!
Thanks,
Jack
Edited 1 time(s). Last edit at 10/01/2018 12:14AM by JackD.
