Cura end code, what am I doing wrong? January 09, 2019 03:47PM |
Registered: 7 years ago Posts: 162 |
G1 Z5.0 F300 ; Move the platform down 5mm G28 X0 Y0 ; Home XY G1 X50 Y50 F6000 ; Move to safe Z-home location G28 Z0 ; Home Z G29 ; Auto bed leveling G1 E3 F220 ; Extract 3 mm that was retracted in End Gcode G92 E0 ; Set E back to zero to begin print
M104 S0 ; Set hotend to 0 M140 S0 ; Set heated bed to 0 G91 E-3 F220 ; Retract 3mm G91 Z5 F300 ; Raise head 5mm G90 X10 Y10 F6000 ; Go to (almost) home M84 ; Shut down machine
Re: Cura end code, what am I doing wrong? January 09, 2019 06:18PM |
Registered: 9 years ago Posts: 465 |
M104 S0 ; Turn off hotend M140 S0 ; turn off heated bed G91 ; set relative positioning G1 E-3 ; retract 3mm G90; set absolute positioning G1 X10 Y10 F6000 ; send print head close to origin. M84 ; power down motors