I have an Anycubic Kossel Linear Plus with a BTT SKR 1.3 running Marlin 2.0, with DRV8825 drivers and with a BLTouch. When I start up my printer the BLTouch runs through its test fine, and the extruder and bed prehead correctly, but when I try to home or level my printer the three vertical guides move upward, locate on the touch sensors, and then the three carriages move downward about a 1/4 of the way down and then stop. The printhead is then suspended about a 1/3 of the way down, nowhere near the build plate. Leveling and homing both perform this same action. The only way I can get the printhead to move down to the buildplate is by using Pronterface and removing the soft endstops, but then I get out of bounds errors. I have included my configuration files.
