Hotend temperature decreasing but firmware not see that November 27, 2019 06:38PM |
Registered: 4 years ago Posts: 2 |
Re: Hotend temperature decreasing but firmware not see that February 04, 2020 05:56PM |
Registered: 8 years ago Posts: 9 |
Re: Hotend temperature decreasing but firmware not see that February 05, 2020 03:01PM |
Registered: 7 years ago Posts: 619 |
Yes you can drop that fast. The drop from 230 to 100 happens a lot faster than the drop from 100 to 30 does. Same with the bed.Quote
furkanbcr
Hi , im using mks base v1.6 and mks tft v1.0 on my prusa clon.
when im printing sometimes extruder skipping steps and my print is failling. i just did a test on my printer and try to print a vase with %25 scale 0.25 mm layer hight 0.4 mm nozzle and 235 C with abs. (with my PLA test , its worst).My printer stop at %75 of print and didt go again . after then that i restart the printer immeditaly and check the temperature. howend temperature was 100 C and bed somethink lie 50C. print was stop like 20 - 30 sec ago and it cant drop that fast to 100 C from 235 C. i think my hotend temperature is dropping when im printing but firmware dont see that. what can i doo about that , how can i fix this?
Re: Hotend temperature decreasing but firmware not see that February 06, 2020 08:11AM |
Registered: 8 years ago Posts: 413 |
Re: Hotend temperature decreasing but firmware not see that February 19, 2020 07:52PM |
Registered: 8 years ago Posts: 9 |
Re: Hotend temperature decreasing but firmware not see that February 20, 2020 07:26AM |
Registered: 8 years ago Posts: 413 |
Re: Hotend temperature decreasing but firmware not see that February 20, 2020 05:44PM |
Registered: 8 years ago Posts: 9 |
Re: Hotend temperature decreasing but firmware not see that February 20, 2020 06:11PM |
Registered: 8 years ago Posts: 9 |