Hi,
The extruder on my Anycubic kossel is refusing to turn.
I'm using a SKR 1.4 mainboard with TMC2209 drivers, Marlin 2.0.x and a knock off e3d Titan
The steppers do enable when I try to move via the lcd.
It isn't jammed. when the printer is off if moves freely.
The driver and stepper are good.
I tried reflashing the firmware and did a factory reset
I have no clue what could be causing this.
Any of you guys know what to try next
Thanks in advance!
Edited 1 time(s). Last edit at 04/03/2020 11:44AM by deodutie.