Welcome! Log In Create A New Profile

Why my printing stay in last step ?

Posted by IMGeorge

IMGeorge

Why my printing stay in last step ?
December 05, 2012 02:28AM

Registered: 11 years ago
Posts: 19

Some of my printing always stay in last step,the hotend do not homing.But some printing hot end will go home when finish printing.I am using 0.8.4 version,last gcode is
M104 S200 ; turn off temperature
M190 S75 ; set bed temperature
G28 X0 ; home X axis
G28 Y0 ; home Y axis
M84 ; disable motors
but some are do not executing these g-code,especially that I draw it with Ironcad then output stl files.

Reply Quote

tmorris9

Re: Why my printing stay in last step ?
December 05, 2012 03:02AM

Registered: 11 years ago
Posts: 1,171

Could you provide a g-code file that does this?

0.7.2b is the most stable version though it's missing a few frills.

You can look at the g-code at the bottom on make sure the command is there

Reply Quote

imecproto

Re: Why my printing stay in last step ?
December 05, 2012 10:45AM

Registered: 11 years ago
Posts: 41

The code Extruder temperature turning off should be M104 S0

and you are using M190 S75; it waits for the bed temperature to reach 75 deg Celsius

so the nozzle doesn't go home after the printing is completed