Bug? Report Slic3r 115 vs 100 empty gcode for thin object
Posted by shafri
|
Bug? Report Slic3r 115 vs 100 empty gcode for thin object June 29, 2014 09:33PM |
not sure bug or feature. but later version 114 and 115 produce empty space when slicing too small/thin section. ver 100 produce not empty, so ok its good. i dont think printing on the air after empty layer/space is a good idea? please see attached picture for comparison v100 and v115.
Edited 1 time(s). Last edit at 06/29/2014 09:34PM by shafri.
Edited 1 time(s). Last edit at 06/29/2014 09:34PM by shafri.
Sorry, only registered users may post in this forum.