I have 2 prints of similar objects. 1 has default settings for accel.- 1 has accel of 6000.
The 1 with 6000 shows a more pronounced overshoot on the corner where Slic3r starts.
Actually, it isn't overshoot b/c the head was moving toward the edge (leading edge) -
there is a VERY slight trace of actual overshoot on the other 3 corner trailing edges.
U can see the top 2mm doesn't show the overshoot b/c slic3r decided to chg the start point.
The overshoot on the other piece is about 1/2 of this one.
So how would this be corrected? Is it an over extrusion at the start point?