Repetier-Host / Speed multiply / R2C2

somebuddy

Repetier-Host / Speed multiply / R2C2_Teacup
July 01, 2013 08:37AM

Registered: 10 years ago
Posts: 23

Hey guys,

Im using a R2C2 Board. I think it is a teacup firmware "clone". The speed slider is greyed out in Repetier Host. Is there any possibility to change the speed during the print process ?

thx

Greetings from Germany

Reply Quote

repetier

Re: Repetier-Host / Speed multiply / R2C2_Teacup
July 01, 2013 10:04AM

Registered: 12 years ago
Posts: 2,705

The sliders are only activated for firmwares known to support speed/flow change during print. Does Teacup support M220/M221 to change these values during print? In that case I could enable that for teacup in the next update.

Repetier-Software - the home of Repetier-Host (Windows, Linux and Mac OS X) and Repetier-Firmware.
Repetier-Server - the solution to control your printer from everywhere.
Visit us on Facebook and Twitter!

Reply Quote

somebuddy

Re: Repetier-Host / Speed multiply / R2C2_Teacup
July 01, 2013 03:06PM

Registered: 10 years ago
Posts: 23

I'dont know if the r2c2 Version of Teacup supports the M220 and M221.
How can i test it ?

Reply Quote

repetier

Re: Repetier-Host / Speed multiply / R2C2_Teacup
July 01, 2013 03:48PM

Registered: 12 years ago
Posts: 2,705

Send it. During a print send M220 S150 and see if speed increases by 50%.

Repetier-Software - the home of Repetier-Host (Windows, Linux and Mac OS X) and Repetier-Firmware.
Repetier-Server - the solution to control your printer from everywhere.
Visit us on Facebook and Twitter!

Reply Quote

somebuddy

Re: Repetier-Host / Speed multiply / R2C2_Teacup
July 03, 2013 05:26AM

Registered: 10 years ago
Posts: 23

Bad M-code 220 sad smiley

Reply Quote

repetier

Re: Repetier-Host / Speed multiply / R2C2_Teacup
July 03, 2013 06:02AM

Registered: 12 years ago
Posts: 2,705

Sorry to hear that was right with teacup not supporting that code.

Repetier-Software - the home of Repetier-Host (Windows, Linux and Mac OS X) and Repetier-Firmware.
Repetier-Server - the solution to control your printer from everywhere.
Visit us on Facebook and Twitter!

Reply Quote

somebuddy

Re: Repetier-Host / Speed multiply / R2C2_Teacup
July 03, 2013 10:17AM

Registered: 10 years ago
Posts: 23

Then you have to make a portation of repertier firmware for the r2c2 board winking smiley

Greetings

Reply Quote