Can anyone help with my Repetier Thermistor table please November 01, 2013 06:28AM |
Registered: 13 years ago Posts: 104 |
Re: Can anyone help with my Repetier Thermistor table please November 01, 2013 09:15AM |
Registered: 12 years ago Posts: 2,705 |
Re: Can anyone help with my Repetier Thermistor table please November 04, 2013 08:18AM |
Registered: 13 years ago Posts: 104 |
Re: Can anyone help with my Repetier Thermistor table please November 04, 2013 08:58AM |
Registered: 12 years ago Posts: 2,705 |
#define NUMTEMPS_4 20 const short temptable_4[NUMTEMPS_4][2] PROGMEM = { {1*4, 430*8},{54*4, 137*8},{107*4, 107*8},{160*4, 91*8},{213*4, 80*8},{266*4, 71*8},{319*4, 64*8},{372*4, 57*8},{425*4, 51*8}, {478*4, 46*8},{531*4, 41*8},{584*4, 35*8},{637*4, 30*8},{690*4, 25*8},{743*4, 20*8},{796*4, 14*8},{849*4, 7*8},{902*4, 0*8}, {955*4, -11*8},{1008*4, -35*8} };
Re: Can anyone help with my Repetier Thermistor table please November 06, 2013 12:34PM |
Registered: 13 years ago Posts: 104 |
Re: Can anyone help with my Repetier Thermistor table please November 06, 2013 12:47PM |
Registered: 12 years ago Posts: 2,705 |
Quote
Flackster
Hi,
I tried a 100K thermister & had same problem. I'm thinking I may have something else set in the firmware that causes problems. Could you post/email me a working example of firmware (Marlin or Repetier - but have the same problem). Keep getting that MINTEMP has been triggered.
Everything checks out fine on my Gen6 (marlin) board so I'm assuming this is RAMPS1.4 specific.
Also, I have no heated bed so T1 has no thermister connected to measure bed temperature. Could that be causing a MINTEMP trigger?
Cheers
Pete
SOLVED - Can anyone help with my Repetier Thermistor table please November 14, 2013 09:47AM |
Registered: 13 years ago Posts: 104 |