infill not infilling

Hi All

I've been printing with some success but recently noticed that although the walls look ok im not getting the infill I expect. even the different wall perimeters aren't together if you know what i mean

The attached is the calibration object from triffids calibration pages and after getting the extruder calibrated to run 100mm through thought id the fine tune. but as you can see it didnt do as expected. the infill is supposed to be 95% or 0.95 as entered in to slic3r.

Any ideas would be a great help.

25 views and no ideas??

drive through calibration once again, your slicer software is not good calibrated.


check fillament diameter, nozzle size, decrease speed, check extruder motor for skipping steps etc...