Welcome! Log In Create A New Profile

Advanced

Z axis go wrong feed rate

Posted by Proteas 
Forum List Message List New Topic
Proteas
Z axis go wrong feed rate
March 02, 2014 06:35PM
When to go manual control and put button to z axis 10mm my 3 d printer go 20 mm feed.
I change many times feed rate z axis.
I have now feed rate 100 mm
Thank you
Reply Quote
Jomo
Re: Z axis go wrong feed rate
March 02, 2014 08:15PM
The feed rate is how fast the axis moves. I think you need to be adjusting the steps per millimeter in the firmware
Reply Quote
Proteas
Re: Z axis go wrong feed rate
March 03, 2014 03:11AM
My feed rate to z axis to printer setting is 100 mm/min and when to put the manual control to z axis to move 10 mm my machine to move 20 mm.
Thank you
Reply Quote
repetier
Re: Z axis go wrong feed rate
March 03, 2014 06:16AM
Thats exactly what Jomo trie dto explain. Yout steps per mm are 100% to high. Set it to 50% of current value in eeprom settings and it would match. Thas has nothing to do with feedrate. Feedrate is speed and steps per mm influence distances.

Repetier-Software - the home of Repetier-Host (Windows, Linux and Mac OS X) and Repetier-Firmware.
Repetier-Server - the solution to control your printer from everywhere.
Visit us on Facebook and Twitter!
Reply Quote
vreihen
Re: Z axis go wrong feed rate
March 03, 2014 06:19AM
Check the micro step jumpers on your electronics board.....
Reply Quote
Newer Topic Older Topic
Sorry, only registered users may post in this forum.

Click here to login