Welcome! Log In Create A New Profile

EEPROM MODE

pangkahang

EEPROM MODE
April 25, 2014 10:07PM

Registered: 10 years ago
Posts: 4

My firmware version is 0.91 and i want to hold the calibrated data into EEPROM.
What's the EEPROM mode should be 0 or 1 or 2.
Also, what's the different between mode 0/1/2？
i'm calibrate the z height again via LCD 《not connect to PC》
after i power off and on the printer.
The calibrated z heigh was gone.
It seem to be not saved into epprom of LCD card....any solution？

Edited 3 time(s). Last edit at 04/26/2014 11:25PM by pangkahang.

Reply Quote

MrDoctorDIV

Re: EEPROM MODE
April 26, 2014 12:42AM

Registered: 10 years ago
Posts: 790

EEPROM mode is simply a state of change. If the EEPROM numbers are different between configuration.h and EEPROM then the EEPROM is overridden with the new settings. If they are the same, the EEPROM is read instead of the configuration.h. Look up the EEPROM Trap to learn more.

Reply Quote

repetier

Re: EEPROM MODE
April 26, 2014 12:12PM

Registered: 12 years ago
Posts: 2,705

Repetier-Host 0.95 can also save your eeprom data into a file and restore it from file. Just to be on the save side!

Repetier-Software - the home of Repetier-Host (Windows, Linux and Mac OS X) and Repetier-Firmware.
Repetier-Server - the solution to control your printer from everywhere.
Visit us on Facebook and Twitter!

Reply Quote

MrDoctorDIV

Re: EEPROM MODE
April 26, 2014 02:34PM

Registered: 10 years ago
Posts: 790

Quote
repetier
Just to be on the save side!

I see what you did there!

Reply Quote

vreihen

Re: EEPROM MODE
April 26, 2014 02:59PM

Registered: 10 years ago
Posts: 903

Quote
repetier
Repetier-Host 0.95 can also save your eeprom data into a file and restore it from file. Just to be on the save side!

Thank you for the reminder about this feature! I just grabbed a backup of my current calibration setting, just to be safe in case they accidentally get whacked when I do the next firmware upgrade.....