Control led strip using output of not used hotend 2

Hi,

I would like to know if is possible to configure repetier to control an led strip connected to the output 12v of the second hotend? The board is radds 1.5 and is was 3 output 12v for 3 hotend. My printer only have 1 hotend and i have the led strip connected directly to the 12 v power supply and is always on.

I want to control the light the same way i can control the hotend. What is the best way to do this?

Set case light pin to that output pin and enable case light.

---

Repetier-Software - the home of Repetier-Host (Windows, Linux and Mac OS X) and Repetier-Firmware.
Repetier-Server - the solution to control your printer from everywhere.
Visit us on Facebook and Twitter!

Nice feature... it was really easy to setup. Thanks repetier.