Over my last couple of prints, I noticed a decrease in the quality of prints...
Today I realized what it was! Looks like the wires in the 2.5t belt have failed.
Tried tightening it, but it quickly stretched again.
Looking at the belt, you can't really see the broken lines, but there is two
wires that you can feel as you run your fingers down the length of the belt.
So looks like I'm outa commission till new belts come in
Sigh... (this is on the X)
Maybe I had the belts too tight?
--------------------------------------------------------
Custom all metal CoreXY
- Duet 2 Wifi w/ PanelDue 7i
- 330mm x 360mm x 500mm
- 750w Silicon heater
Custom Mendel90
(Backup printer - Old reliable!) - Sold