Hi there,
you might know, that I'm currently printing the
Raspi+Camera addons for my printer.
But during my faulty prints I recognised, that the two camera bars don't match together:
So I changed the raspberry_pi_camera.scad a little:
module camera_bar(male = false) {
length = bar_length / 2 + (male ? -bar_overlap / 2 : bar_overlap / 2);
translate([0, base_depth / 2 - bar_y, 2 * 1.2])
difference() {
union() {
tube(or = bar_dia / 2, ir = bar_dia / 2 - bar_wall, h = length - 2 * 1.2, center = false);
if(male)
translate([0, 0, length - 6 * layer_height])
cylinder(r = bar_dia / 2 - wall - 0.1, h = bar_overlap + 6 * layer_height);
}
if(!male)
translate([0, 0, length])
cylinder(r = bar_dia / 2 - wall, h = 2 * bar_overlap + 2, center = true);
*translate([-100, 0, 0])
cube([200, 200, 200]);
}
}
Where does the 2 * 1.2 come from? It's defined in frame_edge_clamp.scad:
pivot_h = 1.2;
This gives me matching bar clamps - I hope - ask me in a few hours ... ;-)
MfG / Regards
Stefan
Blog /
Gallery /
Wiki /
Mendel90 kit since Sep 2013 from Nophead / Original Prusa I3 MK3 since Feb 2018 /
OpenScad Workshop:
Kursdateien
Octoprint Patron since April 2016