Welcome! Log In Create A New Profile

Advanced

E3D Titan Extruder on Mendel90

Posted by amr_dwarf 
E3D Titan Extruder on Mendel90
May 22, 2016 03:00PM
Has anyone here mounted a E3D Titan extruder to their Mendel90?

If so it would be nice to hear experiences and to se photos of how you mounted it.

[e3d-online.com]

Cheers
/ Tobbe
Re: E3D Titan Extruder on Mendel90
May 22, 2016 07:38PM
Re: E3D Titan Extruder on Mendel90
July 17, 2016 03:10PM
So I finally managed to get the Titan mounted on my Mendel90. It took three version of the holder :-)

Now I am trying to figure ot the E-step settings and how hard to tighten the tensioner for PLA.

The E-steps should in theory be easy as E3D writes in their instructions that it is 417.
But that overextrudes quite a bit. So it is calibration time.

As for spring tension on the idler roller, does anyone have any advise?
Re: E3D Titan Extruder on Mendel90
July 17, 2016 03:20PM
Now I am really confused.

It does not matter what value I put in "#define E_STEPS_PER_MM" It extrudes the same length all the time.......

Can someone point me in the right direction here, I do not understand whats going on?


// Tobbe
Re: E3D Titan Extruder on Mendel90
July 17, 2016 04:03PM
If you're using Marlin with the EEPROM enabled, you need to send a M502, followed by a M500 to update the EEPROM to the new settings. Marlin defaults to what's in the EEPROM.

Edited 1 time(s). Last edit at 07/17/2016 04:04PM by stephenrc.
Re: E3D Titan Extruder on Mendel90
July 18, 2016 01:32PM
Doh!

Thank you Stephenrc!

That goes to show how often I calibrate my printer. Had totally forgot that I enabled eeprom when installing Paneloulo2.

Now for some interesting testing with the E3D Titan.

I will follow up with pictures of my mounting as I ended up doing my own solution.
Re: E3D Titan Extruder on Mendel90
July 21, 2016 06:33PM

I wanted the lid of the Titan facing the front but it required major surgery of the frame.
The parts I printed are at [www.thingiverse.com]

Edited 3 time(s). Last edit at 07/21/2016 06:54PM by Ralph.Hilton.
Re: E3D Titan Extruder on Mendel90
July 28, 2016 02:29PM
I put my titan sideways.



The part to the right is removable to get the lid of the titan.
X-carriage is original and also the holder for the little break out board and D-sub connector. The part that on the original mendel 90 bolted to the end of the extruder motor was reused.



Edited 1 time(s). Last edit at 07/28/2016 02:30PM by amr_dwarf.
Re: E3D Titan Extruder on Mendel90
September 01, 2016 12:19PM
@amr_dwarf

can your design be downloaded somewhere?
Re: E3D Titan Extruder on Mendel90
September 02, 2016 10:52AM
The STL-files are attached to this post.

Titan_holder.zip
Sorry, only registered users may post in this forum.

Click here to login