Hi,

Has anyone printed with Woodfill? How does the mendel90 cope with it and what sort of settings should I be using? Is it the same settings as PLA?

Thanks

Hi,

I printed with bamboofill from colorfabb and it went really well. For the settings I would recommend to go with the suppliers suggested settings. Formbamboo fill colorfabb recomends slightly slower speeds. I think I printed between 30 - 40 mm/s with 215°C and bed at 60°C.
The quality was really good and I even sanded the print with very fine sandpaper to get a more woodlike like ( sanding gave it a little irregular color tone).

Regards
Mathias