installing drivers
February 10, 2015 09:23PM
Hi, this is my first post, Is there a correct way to fit the stepper drivers to ramp 1.4, I have seen no articals anywhere saying which way have seen photos of them eitherway,cheers
Re: installing drivers
February 12, 2015 06:18PM
Orient the RAMPS board so the power connectors are to the left. The stepper drivers should be placed with the trim pot (shiny metal circle) to the right.

That's with reasonably standard drivers. What drivers do you have?

[] - suppliers of quality, affordable 3D printer kits and filament for the UK market.
Re: installing drivers
August 20, 2015 10:10PM
This section of the forum is about the magazine. Please move to another section.
Re: installing drivers
December 13, 2015 03:42AM

Edited 2 time(s). Last edit at 12/13/2015 03:57AM by Dust.
Re: installing drivers
December 13, 2015 04:01AM
Hope i am in the right forum !
I need help thats for sure i try to load Marlin into my Board its a Rumba i have the device loaded into device manager serial port 12
i use aurdinio 1.6 and Marlin for my TK300 printer I open and i use config,h But when trying to verifye i get forbidden reg name etc and it stops What have i forgotten `

i manage to build everything i want but i am still useles about aurdinio set up pleas give me advice whats the problem
carl-eric from Sweden
Sorry, only registered users may post in this forum.

Click here to login