Hot End kit on eBay

Hi,

I've found a hot end kit on eBay - might be of interest if someone's wanting to make some offspring!

HTH

Simon

---

RS Ormerod No 192

Looks nice but one should be aware that there is no tip cooling provided so a separate fan would normally be used with this type I think.

Rory

Imitation is the sincerest form of flattery, I suppose...

Ian
RepRapPro tech support

Quote
droftarts
Imitation is the sincerest form of flattery, I suppose...

Open Source hardware is intended to be copied.

You guys really don't seem to be on board with the whole Open Source idea.

---

What is Open Source?
What is Open Source Hardware?
Open Source in a nutshell: the Four Freedoms
CC BY-NC is not an Open Source license

bobc: I suggest you read [www.oshwa.org] and [opensource.com] and point out where you think we're going wrong. I'm free to criticise anyone I feel like, just like you are. We're not stopping anyone from copying RepRapPro designs (which, in turn, may or may not be based on previous work); though I'd prefer they took it, improved it (as we have), and fed back to us what they did, to move everything on (as we have). But then my preference doesn't stop people simply copying.

Ian
RepRapPro tech support

Edited 1 time(s). Last edit at 01/04/2014 01:05PM by droftarts.

droftarts:do you think it will be available again your hothend in emakeshop site?

---

[www.falla3d.com]
[3dita.blogspot.it]

ifala: All spare parts are available, if you email info at reprappro dot com we can sell you any part direct. We have taken the stock of spare parts off emakershop as we are just too busy with the Ormerod to sell extra spare parts.

Ian
RepRapPro tech support