Ormerod - Y axis moves un proportionate May 13, 2014 03:10AM |
Registered: 10 years ago Posts: 1 |
Re: Ormerod - Y axis moves un proportionate May 13, 2014 04:44AM |
Registered: 13 years ago Posts: 1,611 |
Re: Ormerod - Y axis moves un proportionate May 13, 2014 07:12AM |
Registered: 10 years ago Posts: 24 |
Re: Ormerod - Y axis moves un proportionate May 13, 2014 09:59AM |
Registered: 10 years ago Posts: 176 |
Quote
Crouchy
I'm also having problems with my Y-axis moving at random. I'm not seeing any "humping" of the drive belt, so I don't think its too loose. Can the belt being too tight have the same effect? This is happening in about one out of every four prints. Reprinting the same file will usually work perfectly.
Re: Ormerod - Y axis moves un proportionate May 13, 2014 10:01AM |
Registered: 13 years ago Posts: 1,611 |
Re: Ormerod - Y axis moves un proportionate May 13, 2014 12:44PM |
Registered: 10 years ago Posts: 859 |
Re: Ormerod - Y axis moves un proportionate May 14, 2014 05:39AM |
Registered: 10 years ago Posts: 24 |
Re: Ormerod - Y axis moves un proportionate May 14, 2014 06:38AM |
Registered: 13 years ago Posts: 1,611 |
Re: Ormerod - Y axis moves un proportionate May 14, 2014 09:57AM |
Registered: 10 years ago Posts: 2,472 |
Quote
Crouchy
I went back and had a look at my recent stepped prints and they were all at the top of an arch. I had noticed that the prints do tend to curl up at this point, but in most cases the edge would melt back in to place when the nozzle came back around.
Crouchy