Custom start code for firmware 078d-dc42 July 18, 2014 09:32AM |
Registered: 10 years ago Posts: 18 |
Quote
G21 ; set units to millimeters
G90 ; use absolute coordinates
M83 ; use relative distances for extrusion
M107 ; Fan Off
G1 Z5 F200 ; lift nozzle
G1 X2 Y190 F2000 ; Go to wait for warm position
M190 S65 ; wait for bed temperature to be reached
T1; Select extruder
M109 S205 ; wait for nozzle temperature to be reached
G90 ; use absolute coordinates
M83 ; use relative distances for extrusion
G1 X2 Y150 F2000; Go to start position
M107
G1 X2 Y190; park the machine
M0; stop
Re: Custom start code for firmware 078d-dc42 July 18, 2014 09:45AM |
Registered: 10 years ago Posts: 14,672 |
Re: Custom start code for firmware 078d-dc42 July 18, 2014 09:55AM |
Registered: 10 years ago Posts: 18 |
Re: Custom start code for firmware 078d-dc42 July 18, 2014 04:32PM |
Registered: 10 years ago Posts: 14,672 |
Re: Custom start code for firmware 078d-dc42 July 19, 2014 05:02AM |
Registered: 10 years ago Posts: 14,672 |
Re: Custom start code for firmware 078d-dc42 July 19, 2014 06:35AM |
Registered: 10 years ago Posts: 780 |
Quote
lvperlo
Since I've updated to 078d-dc42 I needed to update the slic3r custum start code anyway and tried to clean up some code
I want the machine to go to the warm-up position first and then heat up bed and nozzle, in that order.
Why does the following code not work?
It does not go to the warm-position, but starts heating where it is and waits
Kind regards,
Leon
Quote
G21 ; set units to millimeters
G90 ; use absolute coordinates
M83 ; use relative distances for extrusion
M107 ; Fan Off
G1 Z5 F200 ; lift nozzle
G1 X2 Y190 F2000 ; Go to wait for warm position
M190 S65 ; wait for bed temperature to be reached
T1; Select extruder
M109 S205 ; wait for nozzle temperature to be reached
G90 ; use absolute coordinates
M83 ; use relative distances for extrusion
G1 X2 Y150 F2000; Go to start position
M107
G1 X2 Y190; park the machine
M0; stop
Re: Custom start code for firmware 078d-dc42 July 24, 2014 01:58PM |
Registered: 10 years ago Posts: 18 |