New firmware 1.00q-dc42 - Proterface upload issue

Hi All
I have loaded the New firmware 1.00q-dc42 however since I loaded it Pronterface does not work correctly as before,
I used to do the following:
1- Load a g-file into Pronterface
2- Then Upload the g-file to the SD card
3- then start the print by doing an SD print on could then disconnect and unplug the Laptop and the printer was on it`s own

Now I load the file as before HOWEVER
the printer starts to print immediately when I upload the file to the SD card, in the past it simply uploaded to the SD card
Also one cannot disconnect during this process as the printer stops printing all together and cannot continue....

Mnnn this makes me want to go back to 78c...

Any resolution to this issue ?
Tx Ben

I'll check it out.

---

Large delta printer [miscsolutions.wordpress.com], E3D tool changer, Robotdigg SCARA printer, Crane Quad and Ormerod

Disclosure: I design Duet electronics and work on RepRapFirmware, [duet3d.com].

I confirm this this is a bug in 1.00q - sorry! I have fixed it, and I will do another release as soon as the current test print has completed.

---

Large delta printer [miscsolutions.wordpress.com], E3D tool changer, Robotdigg SCARA printer, Crane Quad and Ormerod

Disclosure: I design Duet electronics and work on RepRapFirmware, [duet3d.com].