Cannot print a bar...ends keep curling up March 22, 2015 11:35AM |
Registered: 9 years ago Posts: 78 |
Re: Cannot print a bar...ends keep curling up (solved) March 22, 2015 12:24PM |
Registered: 9 years ago Posts: 78 |
Re: Cannot print a bar...ends keep curling up March 22, 2015 01:53PM |
Registered: 10 years ago Posts: 14,672 |
Re: Cannot print a bar...ends keep curling up March 22, 2015 04:14PM |
Registered: 9 years ago Posts: 78 |
Re: Cannot print a bar...ends keep curling up March 22, 2015 04:50PM |
Registered: 10 years ago Posts: 14,672 |
Re: Cannot print a bar...ends keep curling up March 25, 2015 09:37AM |
Registered: 10 years ago Posts: 176 |
Re: Cannot print a bar...ends keep curling up March 26, 2015 12:05PM |
Registered: 9 years ago Posts: 18 |
Quote
VortyZA
I haven't used Kapton tape for more than a year now - I use 'extreme hold' hairspray straight on the glass for PLA and haven't needed anything else since I started that. I found the Kapton was difficult to source, expensive when you could, was difficult to apply nicely and caused artifacts on the print - pieces dislodging and sticking to the print, or causing little lines from accidental overlaps.
Re: Cannot print a bar...ends keep curling up March 26, 2015 01:25PM |
Registered: 9 years ago Posts: 62 |
Quote
VortyZA
I haven't used Kapton tape for more than a year now - I use 'extreme hold' hairspray straight on the glass for PLA and haven't needed anything else since I started that. I found the Kapton was difficult to source, expensive when you could, was difficult to apply nicely and caused artifacts on the print - pieces dislodging and sticking to the print, or causing little lines from accidental overlaps.
Re: Cannot print a bar...ends keep curling up March 27, 2015 02:57PM |
Registered: 9 years ago Posts: 78 |